Wolfgang Puck BBLFP050 manual Blender Helpful Hints, Using Your Food Processor With Chopping Blade

HSN_3n1BlenderManual 6/25/10 11:06 AM Page 9

Blender Helpful Hints

•Do not place any utensil (spatula, fork, etc.) in the Blender container while the Blender is operating. If you need to scrape ingredients from the sides of the jar, first stop the Blender and wait for the blades to completely stop moving.

•When blending solid foods, always cut them into no larger than

1-inch pieces before placing them into the jar. Blend no more than 1/2 cup of these foods at a time for uniform blending.

•Remember that ice cubes vary in size and shape. Smaller ice cubes can be chopped or crushed faster than larger ones. To add ice cubes to mixtures while the Blender is operating remove the Filler Cap and drop through the opening. Never attempt to crush ice utilizing your Food Processor Bowl. As a general rule, add no more than 3 cups of ice to 4 cups of liquid.

•If too much food is blended at one time, the motor may stall. If this happens, stop the Blender, turn switch off, unplug from wall outlet, remove a portion of the food and repeat the blending process.

•Always add liquid ingredients first, followed by solid ingredients.

•To add food or liquid while the Blender is operating, remove the Filler Cap from the Blender Lid and drop the ingredients through the opening. Remember to replace the Filler Cap when you have finished adding the ingredients.

•Avoid over-blending. Usually, you will need to blend for only a few seconds, not minutes.

•This Blender is not intended to do any of the following tasks: grind meat, mash potatoes, whip cream, knead dough, whip egg whites, or serve as a juice extractor.

•Never place any of the following ingredients into the Blender jar: bones or large pieces of solidly frozen foods or coffee beans. If the food cannot be cut with a knife, do not place in the Blender jar.

Using Your Food Processor

with Chopping Blade

	1 Place the appliance on a flat, stable, level
	surface where it cannot fall.
	2 Place the Mixing Bowl on the Motor Housing
	with the handle at a 90 degree angle (see
	Figure 6). Rotate the Mixing Bowl clockwise
	as far as possible until you hear it click into
Figure 6	place (See Figure 7).
	3 Slide the Processing Blade over the
	Accessory Shaft and push it downwards
	until the locks into place.
	CAUTION: Be careful when attaching and
	removing accessories. The Processing Blade
	is sharp.
Figure 7	4 Place the assembled blade and
	Accessory Shaft over the drive shaft in the
	Mixing Bowl.
	5 Place your ingredients into the Mixing Bowl.
	6 Place the Lid on the Mixing Bowl as show in
	Figure 8 and rotate the Lid clockwise as far
	as possible. The Lid’s protruding lip must be
Figure 8
	slide over the Mixing Bowl’s handle (See
	Figure 9).
	7 Place the Food Pusher into the Food Chute.

Figure 9

9 10