Wolfgang Puck BBLFP050 manual Using Your Food Processor With Slicing or Shredding Disc

HSN_3n1BlenderManual 6/25/10 11:06 AM Page 13

Using Your Food Processor

with Slicing or Shredding Disc

	1	Place the appliance on a flat, stable, level
		surface where it cannot fall.
	2	Place the Mixing Bowl on the Motor Housing
		with the handle at a 90 degree angle (see
		Figures 6 & 7). Rotate the Mixing Bowl
		clockwise as far as possible until you hear it
Figure 13		click into place.
3		Slide the selected disc over the Accessory
		Shaft and ensure that the white center ring
		on the Accessory Disc is flush with the
		Accessory Shaft (see Figure 13)
4		Place the Lid on the Mixing Bowl as show in
		Figure 8 and rotate the Lid clockwise as far
		as possible. The Lid’s protruding lip must be
		slid over the Mixing Bowl’s handle. (See
		Figure 9).
5		Pull the Power Cord out of the storage
		space at the rear of the Motor Housing.
6		Insert the plug into the wall outlet and turn
		the power switch on the side of the Motor
		Housing to the ON position
		If after plugging the cord in, all indicator
		lights are flashing, the Mixing Bowl and/or
		the Lid is not placed correctly on the Motor
		Housing. For safety reasons it is not possible
		to switch on the appliance in Food
		Processor Mode UNLESS both bowl and Lid
		are properly assembled. Check the position
		of the bowl and the Lid and ensure that it
		matches Figures 7 & 9. When the Mixing
		Bowl and the Lid are fitted correctly, only
		the Standby Indicator Light flashes. Only
		then can the appliance be operated.
7		Press the I button for continuous low speed.
		The Standby Indicator Light will dim and the
		blue indicator light will illuminate.

8Add ingredients during use via the Food Chute in the Lid. Use the Food Pusher to push solid ingredients downwards through the filling opening. Do not push too hard, slow steady pressure is all that is needed. Too much pressure could damage the unit.

•Your electronically-controlled motor comes equipped with an automatic overload protection system which serves two functions:

1)Time Protection: After two minutes of continuous operation, the motor will shut off. Fifteen seconds before switching off, the Standby Indicator Light will begin to flash. This prevents the motor from overheating during use; and

2)Overload Protection: In the event of an electrical overload, the motor will automatically shut off. Simply unplug the unit from the outlet. Wait at least 15 seconds before using again.

•To avoid personal injury or damage to the appliance, never insert a hand or another object into the Mixing Bowl while the appliance is operating.

•Always use the Food Pusher to push ingredients. Never use your fingers, a fork or another object to push ingredients.

9You can turn the motor off by pressing the Selected Speed button or if using the P(ulse) button, simply remove your finger from the button. Switch the power off by pressing the power switch, located on the right side of the Motor Housing and unplug from the wall outlet.

10Remove the Mixing Bowl by rotating counter clockwise and

lifting straight up. Remove the Processing Blade with the Accessory Shaft from the bowl before emptying. Remove the Cutting Disc from the Spindle by grasping from the white center ring and lifting straight up.

13 14