Install Rear Axle Plates
1.Remove three bolts from lower axle housing.
2.Place axle plate (4) over axle housing and secure using two cap screws (8) and hardened flat wash- ers (14) in the middle and rear holes.
3.Install cap screw (9) and hardened flat washer (12) in the front hole.
4.Repeat steps to install second axle plate on oppo- site of tractor.
4. 1020649 Axle plate
8.307309 M12 x 1.75P x 60 mm HHCS
9.32333 M10 x 1.25P x 50 mm HHCS
12.44546 3/8 Hardened flat washer
14.57816 1/2 Hardened flat washer
12
9
14
84
Figure 3. Axle Plate Installed, Left Side Shown
Install Rear Rails
1.Attach right rear rail (5) to the outside of axle plate on right side of axle housing using three cap screws (10), hardened flat washers (13), and hex nuts (15). See Figure 4.
NOTE: Rear rail should be on the inside of front mount.
2.Attach left rear rail (6) to the outside of axle plate on left side of axle housing using three cap screws (10), hardened flat washers (13), and hex nuts (15).
5.1020650 Right rear rail
6.1020651 Left rear rail
10.33757 M14 x 2.0P x 60 mm HHCS
13.46070 9/16 Hardened flat washer
15.307825 M14 x 2.0P Hex nut
10 | 13 15 |
| 5 |
Figure 4. Right Rear Rail to Axle Plate Connection
6 Mount Installation | MAN0530 (6/30/2006) |
|
|
