Woods Equipment BW15LH Owner Service, Notice, Seasonal Lubrication, Blades, Blade Removal Figure

Seasonal Lubrication

In addition to the daily recommended lubrication, a more extensive application is recommended season- ally.

1.Fill CV double yokes with 20 pumps of grease with the joints in a straight line.

2.Articulate CV body to maximum angle several times to ensure full coverage of joints.

3.Place joints in the straight position and a add 10 additional pumps of grease to both joints.

4.Wipe telescoping drive clean of all old grease and contaminants.

5.Add a thin layer of new grease over telescoping drive.

BLADES

3.Align crossbar (10) with blade access hole in the cutter frame. Remove nut and lock washer. Carefully drive blade pin (9) out of crossbar.

4.Rotate crossbar and repeat for opposite blade.

NOTICE

■If blade pin (9) is seized in crossbar and extreme force will be needed to remove it, support crossbar from below to prevent gearbox damage.

Blade Installation (Figure 6)

CAUTION

Your dealer can supply genuine replacement blades. Substitute blades may not meet original equipment specifications and may be dangerous.

NOTICE

Before working underneath, read manual instructions, securely block up, and check stability. Secure blocking prevents equipment from drop- ping due to hydraulic leak down, hydraulic system failure, or mechanical component failure.

Blade Removal (Figure 6)

1. Blade kit, CCW

9.Blade pin

10.Crossbar Assembly

36.Stump Jumper Pan

85.Blade lock clip

86.1/2 NC x 1-1/4 HHCS GR5

Figure 6. Blade Assembly

1.Disconnect driveline from tractor PTO.

2.Raise cutter and block securely (see Figure 5).

■Crossbar rotation has clockwise rotation on left gearbox and counterclockwise rotation on the right and center gearboxes when looking down on cut- ter. Be sure to install blade cutting edge to lead in correct rotation.

NOTE: Always replace or sharpen both blades at the same time.

1.Inspect blade pin (9) for nicks or gouges, and if you find any replace the blade pin.

2.Insert blade pin through the blade. Blade should swivel on blade pin; if it doesn’t, determine the cause and correct.

3.Align crossbar (10) with blade access hole in cutter frame. Apply a liberal coating of Never-Seez® or equivalent to blade pin and crossbar hole. Make sure blade offset is down away from cutter.

4.Insert blade pin (9) through blade and align key on blade pin with keyway in crossbar and stump jumper pan. Push blade pin through crossbar.

5.Insert lock washer and nut through blade access hole in cutter frame. Install on blade pin (9) and tighten to 450 lbs-ft.

6.Repeat steps for opposite side.

NOTE: Blade should be snug but should swivel on pin without having to exert excessive force.

(Rev. 3/3/2010)

MAN0810 (9/24/2009)

Owner Service 21