Interference Check
1.Be sure that tractor
2.Check for
3.Contact between tractor lift links and cutter parts can cause damage, especially when turning.
CV Driveline Turning Limits
NOTICE
■You must not exceed a turning angle of 80 degrees at the head of the Constant Velocity drive- line or damage will occur.
1.To check for potential excessive turn angle, disconnect the driveline from tractor.
2.Start engine and turn as far right or left as possible.
3.Shut engine off and try to connect CV driveline to tractor. If it cannot be connected, the turn angle is too severe.
4.Restart engine and straighten angle slightly, shut off engine and try to connect CV driveline to tractor.
5.Repeat the process until the driveline can be connected. The point at which the driveline can be connected is the maximum turn that should be made.
Cutting Height Adjustment
On
NOTICE
■Avoid ground contact with blades. Striking ground with blades produces one of the most dam- aging shock loads a cutter can encounter. If this occurs repeatedly, the cutter, driveline, and gear- boxes will be damaged.
Cutting height range is from 1" to 12". A hydraulic cylin- der or ratchet jack is available for cutting height adjust- ment.
When selecting a cutting height, you should consider the area of operation. If the ground is rolling and has mounds the blades could contact, set the cutting height accordingly. The cutting height (blade edge) is approxi- mately 1" above the bottom of the side skid.
Cutting Height (Normal Mowing) - Center Section
1.Position the cutter on a hard level surface and select an approximate cutting height, Example 6".
2.Raise wings and lock them in the UP position.
3.Use any of the optional cutting height mechanisms to raise or lower the center section to obtain a distance of 5" from bottom edge of skid shoe to the ground.
4.Loosen jam nuts on the attitude rod that runs from the wheel yoke to the tongue.
5.Adjust rod in or out until the rear of the cutter is approximately 1/2" higher than the front.
6.Tighten jam nuts against sleeve.
Cutting Height (Normal Mowing) - Wings
1.Lower wings to normal mowing position.
2.Loosen the jam nut on the adjustable link (turn buckle).
3.Lengthening the link will raise the wing, shortening the link will lower the wing. The rear edge of the wing should be parallel to the ground.
When using the cutter to shred, the rear of the cutter deck should be approximately 1/2" to 1" lower than the front.
TRACTOR OPERATION
Use care when operating around tree limbs and other low objects. Avoid being knocked off tractor and being injured.
Only use a tractor with a Roll Over Protection Structure (ROPS) and seat belt. Securely fasten seat belt.
The cutter is operated with tractor controls. Engage the PTO at a low rpm to prevent excessive loads on the cutter drive system. Increase throttle to recommended PTO operating RPM.
Be sure operator is familiar with all controls and can stop tractor and cutter quickly in an emergency. The operator should give complete, undivided attention to operating tractor and cutter.
MAN0810 (9/24/2009) | Operation 15 |
| |
|
|
