BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:40 AM Page 14

Adjustments

!WARNING Disconnect plug from power source before performing any as-

sembly, adjustment or repair to avoid possible in- jury.

Checking Right 45°

Bevel Stop

1.Lower head assembly and engage head as- sembly lock pin.

2.Slide head assembly completely to the back and tighten the rail lock knob.

3.Rotate table to the 0° miter position.

4.Pull up bevel lock lever to unlock bevel.

5.Move bevel range selector knob to “0°-45° Right” position. (See page 28)

6.Tilt the saw to the right until you feel the stop in the 45° right position. This is where the saw is currently set for the 45° right bevel cut.

7.Use a combination square to check blade at

Combination

Square

the 45° stop. Place the combination square head on the table and press it’s 45° surface against the blade. If the blade does not contact the full length of the square, (figure 7), follow the calibrating procedure.

Calibrating Right 45°

Bevel Stop

1.Lift bevel lock lever to release bevel lock.

2.Tilt saw to 45° right bevel position.

3.Position combination square with 45° surface against blade. (Figure 7)

4.Insert 3 mm “L” wrench into hole in vertical support frame. (Figure 8)

5.Rotate “L” wrench while viewing blade against combination square until it matches 45° sur- face.

6.Adjust bevel pointer to 45° line on bevel scale.

3mm “l”

Wrench

Adjusting

Access

Hole

Bevel

pointer

figure 7. Right 45° Bevel Stop

figure 8. Right 45° Bevel Adjustment

-14-

Page 14
Image 14
Bosch Power Tools 4410, 4310 manual Sembly, adjustment or repair to avoid possible in- jury, Checking Right Bevel Stop