BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:42 AM Page 40
Troubleshooting
Troubleshooting Guide - General
pROBlEM |
| CAUSE | CORRECTIVE ACTION |
|
|
|
|
Blade does not completely cut | 1. | Depth stop screw adjusted | - See Depth Stop Adjustment |
workpiece. |
| for groove cutting. | in the Adjustment section. |
|
|
|
|
Head assembly does not slide | 1. | Slide rail lock knob tight- | - Loosen slide rail lock knob. |
freely when attempting a slide |
| ened. |
|
cut. |
|
|
|
Head assembly slides forward | 2. | Slide rail lock knob not tight- | - Push head assembly com- |
and back when making a chop |
| ened. | pletely against stop. Tighten |
cut. |
|
| slide rail lock knob. |
|
|
|
|
Bevel setting does not hold | 1. | Bevel lock lever assembly | - Tighten bevel lock lever as |
position. |
| needs to be tightened. | shown on page 15. |
|
|
|
|
Accessories
DAf220K Miterfinder™ Digital Angle finder/Compound Cut Calculator/protractor/level
Gives you the information needed to position cuts so that they fit together precisely even if the room is out of square.
MS1226 Replacement (Vertical) Quick Clamp
MS1228 Crown Molding Support Stop (2) Accurately positions and supports crown molding when angled against the fence.
MS1229
Consists of replacement steel rods that extend the total width of base to
MS1230 length Stop Kit.
MS1231 Replacement Kerf Inserts MS1232 Replacement Dust Bag
T3B TracRac™ portable Stand with Wheels T4B
