BM 2610012089
Assembly
Tools Needed for Assembly And Alignment
Combination Square | Hex “L” Wrench | Multi Purpose “L” Wrench 6.5mm |
| (supplied) 1.5mm | (supplied with model 4310 only) |
Combination Square Must be True
Multi Purpose Tool (supplied with model 4410 only)
Draw Light
Line on Board
Along this Edge
Should be no Gap or Overlap when Square is Flipped Over in Dotted Position
Straight Edge of Board 3/4" Thick This Edge Must be Perfectly Straight
10mm/17mm Combination Open End Wrench
Disconnect plug from power source before performing any assembly, adjustment or repair to avoid possible injury.
Unpacking And Checking Contents
Before moving the saw: Lock the miter lock knob in 45° position.
Lock bevel lock handle. Pull the head assembly com- pletely toward you and tighten the slide rail lock knob.
Lock head assembly in the down position.
Never carry the tool by the slide rails, this may cause blade damage.
Never carry the tool by the cord or head assembly power switch handle. Damage to insulation could cause an electric shock. Damage to wire connec- tions could cause a fire.
Models 4310 & 4410 Miter Saws are shipped complete in one box.
1.Separate all parts from packing materials and check each one with the “Table of Loose Parts” to make sure all items are accounted for before discarding any packing material.
2.Table of Loose Parts:
Quick- Action Clamp (Model 4410 only) - Used to clamp workpieces.
Workpiece Clamp (Model 4310 only) - Used to clamp workpieces.
Dust Elbow/Dust Bag - Used to collect saw dust.
(Multi purpose tool model 4410) or multi purpose “L” wrench model 4310) - Should be stored on the right rear base.
Rear Cord Wrap, washer and Screw - Used for wrapping the cord
Miter Lock Knob - Used to lock the table at de sired miter angle.
!WARNING If any parts are missing, do not plug in power cord or turn the
switch on until the missing parts are obtained and are installed correctly.
Rear Cover Tool Storage
The Open End Wrench and Hex Wrenches are stored on the inside rear cover of the saw. To re- move the cover, unscrew the two top and center thumb screws.
Thumb
Screws
