Check Gearbox
1.Place top cover (10) on housing and secure into position using six cap screws (11).
2.Check gearbox for leaks by: plugging all holes except one, applying 4 psi of compressed air, and immersing gearbox in water. Verify gearbox does not leak.
NOTE: Excessive air pressure will damage seals.
3.Remove gearbox from water and dry off.
4.Remove upper plug on right side of housing (oil level hole). Add SAE 80W or 90W EP oil until it runs out side level hole. Replace plug.
5.Install breather (12) in top cover.
Reinstallation on Cutter
NOTE: Gearbox is heavy: do not attempt to move it without mechanical assistance.
1.Place gearbox on cutter and secure into position using four cap screws and lock nuts.
2.Torque hardware to 175
3.Attach all drivelines to gearbox.
4.Install all shields.
1. Bearing
3.Oil seal
4.Snap ring
5.Shim
6.Pinion gear
7.Shaft
8.Gear
9.Shaft
10.Cover
11.M10 x 30 Cap screw 8.8
12.1/2 Breather
Figure 14. Splitter Gearbox Assembly
MAN0805 (4/30/2009) | Dealer Service 29 |
|
|