NOTE: Items 23 & 24 must be installed with square corners on top and facing cylinder as shown.
2.Slide spacer (17) and
3.Attach base end of wing cylinder (4) to cylinder links (23 & 24) using clevis pin (18) and cotter pins (66).
4.Remove plug from base end of hydraulic cylinder. Align cylinder rod end with cylinder lug on the wing and insert
5.Slide spacer (25) over
6.Insert safety pin (45) into the end of
7.Extend cylinder fully & replace plug in base end of cylinder. This trapped air will help push wing down.
8.Install bushing (40), elbow, (41) and hose (42) to the rod end of cylinder (4). See Install Hose Kit (BW180HD), page 39 for complete instructions.
9.Repeat procedure for opposite wing.
23
24
19
|
|
| 22 |
|
|
| 66 |
| 17 |
|
|
|
|
| DP3 |
|
|
|
|
17. | Spacer, 1" | 23. | Cylinder link |
19. | Wing | 24. | Cylinder link |
22. | Headless pin, | 66. | Cotter pin, |
| 1 x 4.08 |
| 1/4 x |
Figure 32. Left Wing
Install Wing Wheel and Hub (All Models)
1.Insert wheel hub into wing wheel yoke arms (6) and align holes.
2.Secure into position using cap screw (54) and flanged lock nut (55).
3.Attach wheel to hub using five lug nuts. Install the chamfered side of the lug nut toward the inside for steel rim for pneumatic tires and rims. Tighten to 75
NOTE: Install the flat side of the nut toward the inside for solid tires and aircraft tires (shown).
4.Install optional dual wheel and hub to inside of wheel yoke arm.
NOTE: Pneumatic (BW180HD models and BW180HB models), notat, and airplane tires are available for this cutter. See page 62 for parts list.
6.Wing wheel yoke arm, right
21. Wheel and hub
39.1/2 NC x 3 HHCS GR5
40.1/2 NC Flanged lock nut
Figure 33. Wing Wheel and Hub Installation - Right
38 Assembly | MAN0805 (4/30/2009) |
|
|