Install Height Adjustment Cylinder (BW180HD)
Refer to Figure 25.
1.Attach base end of cylinder (5) to the spring arm
(3) using clevis pin (18) and two cotter pins (66).
2.Extend cylinder rod and place transport lock bracket (7) over cylinder rod clevis.
3.Position cylinder rod and transport lock bracket between lugs on the wheel yoke tube and align holes.
4.Secure cylinder rod and transport lock bracket to the wheel yoke tube using clevis pin (20) and two cotter pins (66).
5.Install bushing (40), elbow, (41) and hose (42) to the base end of cylinder (5). See Install Hose Kit (BW180HD), page 39 for complete instructions.
NOTE: An optional ratchet (9) is available, and replaces the hydraulic cylinder. Install ratchet jack using the same procedure and hardware used for the installation of the hydraulic cylinder.
Install SMV Emblem (BW180HD)
Refer to Figure 25.
1.Attach SMV mounting bracket (10) to left side of center section as shown using two carriage bolts (56) and flange lock nuts (55).
2.Attach SMV socket (11) to mounting bracket (10) using two carriage bolts (30) and lock nuts (31).
3.Attach SMV emblem (13) to SMV bracket (12) using two round head cap screws (36) and hex nuts (37).
Insert SMV bracket (12) and emblem (13) into socket (11).
3.Spring arm
4.Spring, compression 3.25" x .69" x 9.5"
5.Hydraulic cylinder
7.Transport
9.Ratchet
10.SMV Mounting bracket
11.SMV Socket
12.SMV bracket
13.SMV Emblem
17.Spacer, 1"
18.Clevis pin, 1" x 2.72
19.Clevis pin, 1" x 4.58"
20.Clevis pin, 1" x 5.08"
30.5/16 NC x 3/4 Carriage bolt
31.5/16 NC Lock nut
36.1/4 NC x 1/2 Round head screw
37.1/4 NC Hex nut
40.1/2 NPT x 1/4 NPT Reducer bushing
41.1/4 NPT x 1/4 NPT Restricted
42.1/4 NPT x 1/4 NPT x 156" Hose
53.1/2 NC x 5 HHCS GR5
55.1/2 NC Lock nut
56.1/2 NC x
66.Cotter pin, 1/4" x
Figure 25. Spring Arm and Cylinder Installation
34 Assembly | MAN0805 (4/30/2009) |
|
|
