Install Wheel and Hub (BW180HD)
1.Insert wheel hub into outside of wheel yoke arm (1) and align holes.
2.Secure into position using cap screw (54) and flanged lock nut (55).
3.Attach wheel to hub using five lug nuts. Install the chamfered side of the lug nut toward the inside for steel rim for pneumatic tires and rims. Tighten to 75
NOTE: Install the flat side of the nut toward the inside for solid tires and aircraft tires (shown).
4.Install optional dual wheel and hub to inside of wheel yoke arm.
NOTE: Pneumatic, notat, and airplane tires are available for this cutter. See page 62 for parts list.
1.Center wheel yoke arm
54. 1/2" NC x 3" HHCS GR5
55. 1/2" NC Flange lock nut
Figure 26. Center Section Wheel and
Hub Installation
Install Tongue (BW180HD)
1.Attach tongue (24) to center section using two tongue pivot pins (33) and cotter pins (70).
2.Attach attitude rod (6) to lug on tongue and secure with clevis pin (34), washer (35), and cotter pin (66).
3.Attach parking jack (22) to the side of the tongue.
4.Attach safety chain (8) to the bottom of center gusset and secure with cap screw (40), washer (38), and lock nut (39).
6.Attitude rod
8.Safety chain
22.Parking jack
24.Tongue
33.Tongue pivot pin
34.Clevis pin, 1" x 2.26"
35.Washer, flat 1"
38.Washer, flat 3/4" x 2" x 3/8"
39.3/4" NC Lock nut
40.3/4" NC x
66.Cotter pin, 1/4" x
70.Cotter pin, 3/16"x
Figure 27. Tongue Installation
MAN0805 (4/30/2009) | Assembly 35 |
|
|