Install Wing Wheel Yoke Adjustment Link
CAUTION
Use a suitable lifting device of sufficient capac- ity. Use adequate personnel to handle heavy com- ponents.
1.With a lifting device raise right wing and lock in the up position using the wing
2.Attach adjustable link (8) to right side of center wheel yoke arm and secure with cap screw (28) and lock nut (33).
3.Attach opposite end of adjustable link (8) to wing wheel yoke arm and secure with cap screw (28) and lock nut (33).
4.Remove
5.Repeat process for left wing. (BW126R only has right wing installed; BW126L only has left wing installed.)
8
28
33 | DP2 |
8. Adjustable link
28. 1 NC x
33. 1 NC Lock nut
Figure 34. Left Wing Wheel Yoke
Adjustment Link Installed
Install Wing Driveline
1.Attach clutch shield (16) to wing gearbox using four cap screws (60), lock washers (64), and flat washers (63).
2.Slide non clutch end of driveline (3) over wing gearbox shaft and align holes with groove.
3.Secure driveline to shaft using cap screws and lock nuts supplied with driveline.
4.Slide clutch end of driveline over splitter gearbox and secure using cap screws and lock nuts supplied with driveline.
5.Repeat process for left driveline. (BW126R only has right wing installed; BW126L only has left wing installed.)
3.Driveline, complete
16. Clutch shield
60. M8 x 1.25P x 20 mm HHCS
63. 5/16" Flat washer
64. 5/16" Lock washer
Figure 35. Right Driveline Installation
Install Hose Kit
1.Remove plug from rod end of each wing cylinder.
2.With the wings in the down position and cylinder extended, remove and reinstall the plugs from the base of the wing cylinders. This will trap air behind the piston and help when lowering the wings.
3.Install reducer bushing and restricter elbow into cylinders. Position elbow on center cylinder to point forward; on wing cylinders point elbows to the center.
NOTE: Make sure a breather fitting is installed in the rod end port of the wheel yoke cylinder.
4.Attach hose to each elbow.
(Rev. 10/19/2009) MAN0707 (5/30/2008)
Assembly 39
