1. | Weight box 750 lbs | 29. | 3/8 NC Flange lock nut |
2. | Brace | 30. | 3/8 Flat washer |
3. | Skid shoe | 31. | 3/8 Lock washer |
4. | Mounting plate | 32. | 3/8 NC x |
6. | Sleeve, 1.25 x 1.5 x 3.40 | 34. | Clevis pin, 1 x 2.26 |
15. | Hinge pin | 35. | 1" Flat washer |
27. | Washer, 1 x | 37. | Spring pin, 1/4 x |
28. | 3/8 NC x | 66. | Cotter pin, 1/4 x |
|
|
|
|
Figure 40. Counterweight Installation
BW126 and BW126L Counterweight Installation
■The offset model is unstable without adequate counterweight. Use counterweight box loaded with 750 lbs. of steel.
CAUTION
Use a suitable lifting device of sufficient capac- ity. Use adequate personnel to handle heavy com- ponents.
This unit may be operated with only one wing - either right or left. With only one wing, the unit is unshielded and unstable. When electing to operate with one wing, you must install a counterweight box, available from your dealer. This box has a dual purpose: it substitutes for the shielding and for the weight of the removed wing.
The counterweight must be installed in the following sequence and will require at least two people. A floor jack or a suitable lifting device will be helpful to align the hinges when installing the hinge pin.
Refer to Figure 40.
1.Remove hinge pin (15) from center section.
MAN0707 (5/30/2008) | Assembly 43 |
|
|