Woods Equipment FZ28K, FZ23B Dealer Service, Install Clutch, Align Belt, Reassemble Components

Install Clutch

1.Install clutch spacer (10) over engine shaft with the chamfer side towards the engine. See Figure 14.

10

DP10

Figure 14. Clutch Spacer Installed

2.For FZ23B Only: Align keyway of new D-Drive hub (45) with key of clutch and press into front of clutch. See Figure 15 and Figure 16.

Figure 15. D-Drive Hub Installed

NOTICE

■D-Drive hub must be installed using an arbor press. When installing, inner race must be sup- ported or bearing damage may occur.

All Models

3.Install clutch onto engine shaft.

4.Secure clutch to engine shaft using 7/16 NF cap screw (21) and lock washer (50) previously removed.

NOTE: Place a drop of Loctite 242 (blue) on threads of cap screw before installing.

5.Torque cap screw to 50 lbs-ft.

45

50

21

DP11

10. Clutch spacer (see Figure 14)

21. 7/16 NF HHCS GR5

45. D-Drive hub

50. 7/16 Lock washer

Figure 16. Clutch, D-Drive Hub, & Hardware Installed

6.Check belt alignment and if necessary adjust PTO sheave on shaft. See Align Belt.

NOTE: If belt alignment is not necessary proceed to Reassemble Components.

Align Belt

7.Loosen the taper bolts (13), adjust sheave (2), and tighten bolts to 95 lbs-inch.

2. PTO sheave

13. 1/4 NC x 3/4 HHCS GR5

19. Electric clutch, mag-stop 1-1/8

49. Taper lock

Figure 17. Align Clutch & PTO Sheave

Reassemble Components

1.Install PTO V-belts (22) over PTO sheave (2) and clutch (19).

24 Dealer Service MAN0875 (2/8/2011)