ASSEMBLY
DEALER SET-UP INSTRUCTIONS
Assembly of this Mow’n Machine is the responsibility of the Woods dealer. It should be delivered to the owner completely assembled, lubricated, and adjusted for normal cutting conditions.
Set up the Mow’n Machine as received from the factory with these instructions. Complete the Dealer Check Lists on page 28 when assembly is completed.
Power Unit Preparation
1.Remove crating from around power unit. Remove power unit from pallet and place on blocks.
2.Remove Operator’s Manual from power unit frame and save for original retail purchaser.
NOTE: Dealer must complete and return product registration card at time of sale.
Lubrication
NOTICE
■Running engine without oil will cause engine failure.
1.Check engine oil level (30W).
2.Check that oil levels
NOTE: See Owner Service section for engine, transmission, and lubrication information.
Fuel
Fill fuel tank with the correct fuel. Refer to engine man- ual.
INSTALL DRIVE TIRES
|
| 1 |
1. | Lug Bolt | DP5 |
|
|
Figure 19. Drive Tire Installed
1.Install drive tires using five lug bolts (1) from bag of loose parts shipped with machine.
2.Torque lug bolts to 85
Drive Tire Pressure:
Turf Tires | 12 psi |
Knobby Tires | 12 psi |
Chevron Tires | 10 - 12 psi |
ADJUST STEERING HANDLES
2
1
3
4
DP8
1.Steering lever
2.Steering lever mount
3.5/16 NC x 1 Whiz bolt
4.5/16 Flanged lock nut
Figure 20. Steering Handle Adjustment
The steering handles are shipped loose, inside the foot rest.
1.Remove whiz bolt (3) and lock nut (4) from left steering lever mount (2).
2.Position steering handle (1) to desired location on steering lever mount (2). The top and middle holes are for taller operators and the middle and bottom holes are for shorter operators. Do not tighten hardware at this time. Repeat steps 1 and 2 for right steering handle.
3.Rotate handles inward. Align handles with one another. Torque all hardware to 12
26 Assembly | MAN0875 (2/8/2011) |
|
|
