rear. Place clevis portion of bracket inward and install chain idler in rear hole of bracket clevis.
Install brackets to tractor as shown in Figure 17. There is a plate bolted over clutch housing. When installing right bracket, remove two bottom bolts attaching this plate to tractor. There is a bolt just above these bolts. Remove it. Remove washer and reinstall bolt. Be sure to use the 14 mm bolts provided in mower kit for bracket installation. Place heavy duty lock washer over each bolt.
1.Steering Gear Case*
2.5/8 Heavy Lock Washer
3.14 mm x 1.5P x 35 mm Bolt
4.Right Front Lift Bracket
5.1/2 x 2 Clevis Pin
6.3/16 x 1 Cotter Pin
7.Chain Idler
8.Oil Filter*
* Tractor Parts
Figure 17. Right Front Lift Bracket Installation
1.Chain (to right front lift bracket)
2.Left Front Lift Bracket
3.Chain (to left front lift bracket)
4.1/2 x 2 Clevis Pin
5.3/16 x 1 Cotter Pin
6.1/2 x 2 Clevis Pin
7.Chain Idler
8.14 mm x 1.5P x 35 mm Bolt
9.5/8 Heavy Lock Washer
10.Left Tractor Foot Rest*
* Tractor Part
Figure 18. Left Front Lift Bracket Installation
ATTACHING MOWER TO TRACTOR
Position mower under tractor. It will be necessary to lift front wheels off ground.
A CAUTION
■Use care when moving mower under tractor. Do not get under tractor. Be sure lifting device is safe.
If a lifting device is not available, the mower frame is strong enough to back the tractor over mower. Use care to prevent damage to painted surface when using this method.
Place a wooden block behind each rear tire to act as a ramp. Do not spin tires against mower frame. Back on then drive off.
22 Assembly | 32695 (Rev. 11/17/2006) |
|
|
