Dukane 9060 user manual Installation Optional Lens Installation, Before installation

2. Installation

c Optional Lens Installation

This section describes how to install the lens.

Before installation

*Determine the optional lens to be used to obtain a desired projection distance. There are six optional lenses available: GT13ZLB, GT19ZL, GT20ZL, GT24ZLB and GT34ZLB (Zoom lens)

GT10RLB (Short throw fixed-focus lens)

*Press the power button (ON/STAND BY) on the projector or POWER OFF button on the remote control for a minimum of two seconds to turn off the power, wait 90 seconds (2 minutes in the optional extended life lamp) for the cooling fan to stop, turn off the main power switch then disconnect the power cable.

Check that the projector has cooled off sufficiently before proceeding.

CAUTION

*The projector and lens contain high-precision parts. Do not induce shock to the projector or the lens.

*Do not touch the lens surface. Doing so can degrade the optical performance.

Preparation: Tools needed for installation:

A hexagonal driver and dust-protective sheets are supplied with the optional lens.

1.Remove the lens hood cap and lens hood. q Remove the lens hood cap.

w Loosen and remove the 2 screws on the lens hood using the hexagonal driver. e Remove the lens hood by pushing down and pulling the top toward you.

Lens hood

Lens hood cap

S-
	VIDEO
	B/Cb
	H/
L/MONO	HV
L/MONO	V
R
R

1

3

USB(
MOU
SE/HUB)	USB(PC)		2
		PC	CARD
PC	CONTROL		1
	IN

LAN

OUT

SC	TR		RE
		IGGER	MOTE	1

REMOTE2

IN

OUT

AC IN

3

2

2. Attach a dust-protective sheet.

qRemove the shipping tape on the back of the lens hood. w Insert the dust-protective sheet included with your optional lens. Be careful not to fold the sheet.

1

2

Shipping tape

Insert the dust-protec- tive sheet with the alu- minum side up while bending it.

Hole	Align the holes on
	the right.

2-6