Dukane 9060 user manual Appendix Remote 1 Connector, Pin No

10. Appendix

m REMOTE 1 Connector

5		4	3	2	1
10		9	8	7	6
15	14		13	12	11

This connector is used for a third party external control device.

Pin No.		SHORT/OPEN				FUNCTION
14			SHORT			External control mode ON
			OPEN			External control mode OFF
5			SHORT			POWER ON
			OPEN			POWER OFF
10			SHORT			PICTURE MUTE ON
			OPEN			PICTURE MUTE OFF
3			SHORT			MUTE SOUND ON
			OPEN			MUTE SOUND OFF
4,8,12,11	11pin	12pin		8pin	4pin
	OPEN	OPEN		OPEN	OPEN	RGB 1
	OPEN	OPEN		OPEN	SHORT	VIDEO
	OPEN	OPEN		SHORT	OPEN	S-VIDEO
	OPEN	SHORT		OPEN	OPEN	Slot 1-1
	OPEN	SHORT		OPEN	SHORT	RGB 2
	OPEN	SHORT		SHORT	OPEN	Slot 1-2
	OPEN	SHORT		SHORT	SHORT	RGB1 (S-VIDEO)
	SHORT	OPEN		OPEN	OPEN	DVI (DIGITAL)
	SHORT	OPEN		OPEN	SHORT	VIEWER
	SHORT	OPEN		SHORT	SHORT	RGB1 (VIDEO)
	SHORT	SHORT		OPEN	OPEN	Slot 2-1
	SHORT	SHORT		OPEN	SHORT	Slot 2-2
	SHORT	SHORT		SHORT	OPEN	LAN

*When combinations other than specified in the above table are selected or when no optional board is inserted in the Slot 1 and 2, the input will be switched to RGB 1 by default.

*The term “SHORT” means to connect with pin 15

*When in the external control mode, the POWER, Source/Input, PICTURE MUTE and SOUND MUTE buttons on the remote control will not function.

*When the External control mode is set to ON, the following settings are not effective: Source Select, Auto Start, Power Management, Power off Confirmation, Idle mode, Default Source Select, Timer and Test Pattern.

NOTE: When turning off the power to the projector using the external control, do not disconnect the plug from the power outlet. These procedures are to protect your projector and the connected equipment.

10-9