1. Introduction
Top Features
14 13 12 | 10 | 9 | 8 | 11 | 6 | 7 |
|
|
| MENU |
|
|
|
FZ | UP |
|
|
|
|
|
|
|
|
| 3D | A | |
|
|
|
|
| ||
LEFT | LENS SHIFT RIGHT |
| SELECT |
| 3D REFORM AUTO ADJUST | |
FOCUS ZOOM | DOWN |
PC CARD 1 
PC CARD 2 
LAMP 1
E |
|
|
|
| L |
|
N |
|
|
|
| E |
|
T |
|
|
| C | ON/STAND BY | |
|
| N | ||||
| E | R | A |
| ||
|
| C |
|
|
| |
LAMP 2 |
| STATUS | POWER | |||
5 | 4 | 3 | 2 | 1 |
1. POWER Button (ON / STAND BY)( 
)
Use this button to turn the power on and off when the main power is supplied and the projector is in standby mode or idle mode.
NOTE: To turn on or off the projector, press and hold this button for a minimum of two seconds.
2. POWER Indicator
When this indicator is green, the projector is on; when this indicator is orange, it is in standby or idle mode. See the Power Indicator section on page
3. STATUS Indicator
If this light blinks red rapidly, it indicates that an error has oc- curred, the lamp cover is not attached properly or the projector has overheated. If this light remains orange, it indicates that you have pressed a cabinet key while the Control Panel Key Lock is enabled. See the Status Indicator section on page 10- 3 for more details.
4.LAMP Indicator 1/2
If this light blinks red rapidly, it's warning you that the lamp has reached the end of its usable life. After this light appears, re- place the lamp as soon as possible (See page
5.PC CARD Access Indicator 1/2
Lights while accessing a PC card.
6.3D REFORM Button
Press this button to enter 3D Reform mode to correct the key- stone (trapezoidal) distortion, and make the image square. Press to toggle between Cornerstone and Keystone adjust- ment mode.
NOTE: Pressing and holding this button for a minimum of 2 seconds will reset 3D Reform correction setting values to zero.
7. AUTO ADJUST Button
Use this button to adjust
8.MENU Button
Displays the menu.
9.SELECT (+)
: Use these buttons to select the menu of the item you wish to adjust. When no menus appear, these buttons work as a volume control.
: Use these buttons to change the level of a selected menu item. A press of the button executes the selection.When the menus or the Viewer tool bar is not displayed, these buttons can be used to select a slide, or to move the cursor in Folder List or Slide List.
10.ENTER Button
Executes your menu selection and activates items selected from the menu.
11. CANCEL Button
Press this button to exit "Menus". Press this button to return the adjustments to the last condition while you are in the ad- justment or setting menu.
12. LENS SHIFT Button
Adjust the lens offset by shifting the projected image position horizontally and / or vertically.
13. ZOOM Button
Zoom the lens in and out.
14.FOCUS Button
