Woods Equipment MAN0063 manual #46675 Control Valve Kit & #1001420 Hose Kit

2

#46675 Control Valve Kit & #1001420 Hose Kit

General Description

This hydraulic connection uses a single-lever con- trol valve mounted to the right loader mount with a mounting plate as shown.

IMPORTANT

■Hydraulic valves must be connected to the tractor hydraulic system as shown in the spe- cific loader mounting kit manual.

■If hydraulic lines are not connected as shown in this manual, the loader control valve may be damaged. A blocked outlet (return) or improper hose connection will cause pressurized oil to enter the return circuit and damage the valve.

■Whenever the engine is running, pump flow will be present at the Pressure port. Pressure port must always be connected to the Power-beyond port with hoses with a 3,000 psi rating or through an open-center directional control valve with Power-beyond capability. Power-beyond control valves have three ports: inlet, outlet and return-to-sump.

■Pressure port must never be plugged since this will cause hydraulic oil to exceed relief, quickly overheat, and cause damage to the trac- tor hydraulic system.

■Never use a directional control valve that does not have Power-beyond capability (2 hose connections). Valve spool seal leakage will occur and the valve housing could fracture.

For installing this control valve kit, references to right, left, forward, and rearward directions are determined from the operator’s position in the trac- tor seat.

Figure 12 2-Spool Control Valve Installed (Typical installation)

CAUTION

■If the manifold is used to provide hydraulic power to any implement that is carried off the ground (such as a front end loader), be sure that the implement is fully lowered and pres- sure is relieved before exiting the operator con- trol area.

MAN0063 (12/15/00) Hydraulic Installation 15