Woods Equipment MAN0063 manual Verification of Control Movements

2

#46675 Control Valve & #1001420 Hose Kit Cont’d

Verification of Control Movements

1.Mount loader to tractor: Remove mount pins from loader uprights. Align tractor with loader and slowly drive tractor into loader. Shut off tractor.

2.Connect loader feedline hoses to control valve hydraulic couplers. See Figure 20.

NOTE: At least 6” spacing should be maintained between valve, bracket, or hoses and any tractor control (brake pedals, accelerator, hand throttle, or hydraulic levers).

3.Comply with all Safety Rules and start the trac-

tor.

4.Check that all hydraulic control lever positions operate the loader movements correctly as shown in Figure 21.

5.If loader movements do not respond correctly, shut off tractor, relieve pressure, and reconnect properly. Loader control movements must be cor- rect before proceeding.

6.Once all loader functions are correct, start the tractor and operate the loader to check for leaks. Purge any remaining air from the hydraulic system.

7.When hose routings and correct loader opera- tions are verified, identify each circuit by placing a matching colored band around the male and female quick-disconnect coupler set. The colored bands will make re-installation easier when the loader is removed from the tractor.

8.Be sure that adequate slack is left in the hoses so they can move as the loader moves through its full range of motion.

9.Before operating the loader, make sure that the Pre-Delivery, Delivery, and Pre-Operation Check- lists from the Operator section in the Loader Opera- tor’s Manual have been completed.

)/2$7 326,7,21 ￿￿/(9(5 &21752/

75$&725	/2:(5	'803
)5217

52//%$&. /,)7

Figure 20 Single Lever Control Operation

●Handle Forward - Boom down

●Handle forward to limit - Float position

●Handle back - Boom up

●Handle to right - Dump bucket or attachment

●Handle to left - Rollback bucket or attachment

22 Hydraulic Installation MAN0063 (12/15/00)