Woods Equipment MAN0063 manual #46675 Control Valve & #1001420 Hose Kit Cont’d

2

#46675 Control Valve & #1001420 Hose Kit Cont’d

Assemble Control Valve Kit	8.	46340	Valve mounting plate
1. Install the control lever:	9.	56254	Bent handle
	10.	44592	Hose holder
a.) Thread end of handle (1) into valve.
	11.	53998	Right rear mount
b.) Align handle so that end with longer bend is
pointing toward the adapter fittings. Make sure	30.	20973	3/8 x 1-1/4 Carriage bolt
bends are in line with front and rear of valve.	32.	565	3/8 Flat washer
c.) Tighten jam nut (2) already installed on han-	33.	838	3/8 Lock washer
dle.
	34.	835	3/8 Hex nut
d.) Slide boot down over boot bracket.
	35.	29893	1/2 NC x 1-1/2
2. The valve mounting plate contains two sets of
			Carriage bolt
holes. Select the holes that will position the valve in	36.	3598	1/2 Flat washer
the desired location. Install the valve mounting
	37.	855	1/2 Lock washer
plate (8) over the hose holder (10) and secure to
	38.	13859	Jam nut
the right loader mount, using two 5/8 NC x 2 car-				9
	39.	1093	1/2 Hex nut
riage bolts (40), 5/8 flat washers (41), lock washers
(42), and nuts (43) supplied in loader mounting kit.	40.	2855	5/8 NC x 2
NOTE: Carriage bolts must be installed so that the			Carriage bolt
	41.	3632	5/8 Flat washer
head is inside the loader mount.
	42.	1286	5/8 Lock washer
3. Attach the valve mount to the valve plate so that
	43.	230	5/8 Hex nut
the control valve will be in the correct position for
operation. Secure with three 1/2 NC x 1-1/2 car-				38
riage bolts (35), flat washers (36), lock washers
(37), and nuts (38) as shown.

4.Control valve must be positioned so that move-

ment of tractor controls is not restricted. Maintain at least 6” spacing between control valve kit and any tractor control (brake pedals, accelerator, hand throttle, or hydraulic levers.) Check for clearances in the operating position.

5. Torque all hardware		30	35	8
					34
to specifications given below.				33
					CD5740
		40		32
					36
		10			37
					39
	11			41
				42
				43
.		Figure 13 2-Spool Control Valve Kit Assembly
TORQUE SPECIFICATIONS
	Wrench
Bolt	Size	Required Torque
5/8 NC x 2	15/16”	170 lbs.-ft.(230 N-m)
1/2 NC x 2	3/4”	85 lbs.-ft.(115 N-m)

16 Hydraulic Installation

(Rev 1/25/02) MAN0063 (12/15/00)