Woods Equipment MAN0063 manual Install #1001421 Adapter Plate from Hose Kit

2

#46675 Control Valve & #1001420 Hose Kit Cont’d

Install #1001421 Adapter Plate from

Hose Kit

CAUTION ￿￿￿￿￿￿￿￿

■Before attempting to install this kit, the fol- lowing must be observed:

1.Shut off engine, place transmission in neutral, and apply parking brake.

2.Fully lower any equipment supported by the tractor remote hydraulic valves, if so equipped. Activate any remote valves to relieve all hydraulic pressure in the remote circuits.

3.Fully lower the 3-point hitch.

■Removal of the accessory plate or remote valves with a load being held on the 3-point hitch will result in escape of high pressure oil and sudden, uncontrolled drop of 3-point hitch arms.

3.Install O-rings into #1001421 PBY adapter plate. Use petroleum jelly to keep the O-rings in the counterbores.

1.Thoroughly clean the top front of the hydraulic accessory plate.

2.Remove accessory plate. Be careful not to dis- turb the O-rings that need to stay with the cover plate removed.

4.Place the adapter plate onto the hydraulic lift cover.

5.Place the accessory plate onto the adapter plate. Verify that the seal rings stay in the counter- bores.

6.Secure with hex head cap screws and flat washer as shown in Figure 14.

1.21548 5/16 x 3-1/4 Cap screw

2.4378 5/16 Standard flat washer

3.21549 7/16 x 3 Cap screw

4.1001423 7/16 X 4-3/4 Cap screw

5.----- Hydraulic accessory plate

6.----- Hydraulic lift cover

NOTE: This hardware will be used with the stan- dard accessory plate. If tractor is equipped with an optional auxiliary quick-coupler valve, obtain hard- ware locally.

1 2

5 3

4

6

Figure 13 Adapter Plate Installation (3930 shown)

MAN0063 (12/15/00) Hydraulic Installation 17