Manuals / Brands / Lawn and Garden / Lawn Mower / Woods Equipment / Lawn and Garden / Lawn Mower

Woods Equipment 872500G, 872502G, MZ2661K REAR DECK ROLLERS , HEIGHT OF CUT, COUNTERBALANCE SPRINGS

1 68

Download 68 pages, 6.05 Mb

18

WOODS

ADJUSTMENTS

REAR DECK ROLLERS

The rear outside deck rollers are adjustable up and

down to provide improved deck otation and scalp-

ing protection at various heights of cut. They are not

intended to ride continuously on the ground. Adjust

no closer than 3/8” (10mm) to the ground.

Height of cut ranges for roller adjustment

HEIGHT OF CUT

The height of cut is set by moving height of cut pin C

to the hole designated for the height of cut desired.

To change the height of cut:

1. Lift the deck to the highest position.

2. Move pin C to the selected hole.

3. Lower the deck until the lift lever is stopped by

the pin.

NOTES:

– Height of cut may vary due to the amount of

tread on the tires, tire diameter or ination pres-

sure.

– For best results, adjust the rear deck rollers for

the height of cut to be used (see below).

COUNTERBALANCE SPRINGS

1. Raise the cutterdeck all the way.

2. Adjust the spring A with nut B: The spring length

should be set at approximately 8-3/4", inside loop

to inside loop, when in transport position.

The springs may be tightened or loosened from

this point according to personal preference.

Contents

Main PARTS MANUAL MOWN MACHINE MAN0865 MZ2252K MZ2661K AVERTISSEMENT WARNING IMPORTANT MESSAGE TABLE OF CONTENTS WOODS NOTICE !!! ATTENTION! BECOME ALERT! Signal word denitions Page ASSEMBLY AND SETUP MAINTENANCE CHART ECNANETNIAM NOITAREPO E N I G N E SCILUARDYH ENIHCAM Page CHECK DAILY BATTERY Page HYDRAULIC SYSTEM WOODS SPARK PLUGS ENGINE OIL FUEL FILTER HEAVY DUTY CYCLONIC AIR CLEANER ENGINE COOLING WOODS CLEANING MACHINE WASHING MACHINE Page DECK LEVELING REAR DECK ROLLERS HEIGHT OF CUT COUNTERBALANCE SPRINGS WOODS PARKING BRAKE CONTROL LEVERS TRACKING HANDLES FRONT DECK LIP DAMPERS WOODS HYDROSTAT ADJUSTMENTS BELT REPLACEMENT CUTTERDECK BELT A PUMP-DRIVE BELT POWER UNITS ENGINES: DRIVE SYSTEM: OPERATOR PRESENCE INTERLOCK SYSTEM: WEIGHT: ENGINES WOODS LARENEG ENIGNE CONSTRUCTION: CUTTERDECK DRIVE SYSTEM: CUTTERDECKS Page FIGURE 1 UPPER ENGINE DECK ASSY FIGURE 1 ITEM PART NO. DESCRIPTION QTY ITEM PART NO. DESCRIPTION QTY * NOT ILLUSTRATED UPPER ENGINE DECK ASSY FIGURE 2 LOWER ENGINE DECK ASSY/CLUTCH FIGURE 2 LOWER ENGINE DECK ASSY/CLUTCH FIGURE 3 BUMPER FIGURE 3 FIGURE 4 FUEL TANKS/CONTROL PANEL FIGURE 4 FUEL TANKS/CONTROL PANEL FIGURE 5 BRAKES/REAR WHEEL FIGURE 5 BRAKES/REAR WHEEL FIGURE 6 OIL COOLER FIGURE 6 FIGURE 7 AIR COOLED HYDRAULICS FIGURE 7 AIR COOLED HYDRAULICS FIGURE 8 HYDROGEAR PUMP WOODS HYDROGEAR PUMP FIGURE 9 AIR COOLED WIRE HARNESS BATTERY ENGINE BLOCK (GROUND) (BLACK) (RED) AIR COOLED WIRE HARNESS FIGURE 9 Page SEAT ASSEMBL Y FIGURE 10 FIGURE 11 OPTIONAL FOLDING ROPS KIT (970410) FIGURE 11 OPTIONAL FOLDING ROPS KIT (970410) FIGURE 12 STEERING/DECK LIFT FIGURE 12 STEERING/DECK LIFT FIGURE 13 CRADLE ASSEMBLY FIGURE 13 CRADLE ASSEMBLY FIGURE 14 CRADLE & CASTER ASSEMBLY FIGURE 14 CRADLE & CASTER ASSEMBLY FIGURE 15 52" SIDE DISCHARGE FIGURE 15 52" SIDE DISCHARGE FIGURE 16 61" SIDE DISCHARGE FIGURE 16 61" SIDE DISCHARGE Page Page FIGURE19 DECALS-POWER UNIT FIGURE 19 Page Page Woods Equipment Company LIMITED WARRANTY (Mown MachineTM Zero-Turn Mowers and Woods BoundaryTM Utility Vehicles) LIMITED WARRANTY (Mown MachineTM Zero-Turn Mower and Woods BoundaryTM Utility Vehicle Replacement Parts)