Woods Equipment 872500G, 872502G, MZ2661K WOODS

21

WOODS ADJUSTMENTS

HYDROSTAT ADJUSTMENTS

A turnbuckle-style hydrostat neutral adjustment is

provided.

Neutral:

1. Support the machine with the rear wheels off

the ground. Use jackstands or equivalent sup-

port. Do not rely only on mechanical or hydraulic

jacks.

2. Move the traction levers out into the neutral lock

position and raise the seat.

3. Disconnect the seat switch wire K and

temporarily connect the two terminals with

jumper wire J as shown.

4. Start the engine and run at low speed.

5. Loosen jam nuts T at both ends of the control

rod.

6. Rotate the control rod until the corresponding

wheel stops turning. Lock the jam nuts. Run the

engine up to high idle to check the adjustment.

Readjust if necessary.

7. Repeat steps 5 and 6 for the opposite side.

8. Remove the jumper wire J and reconnect the

seat switch.

Reverse Return:

1. Move traction levers out to the neutral lock posi-

tion and raise the seat.

2. Locknut U should be run on the bolt as far as it

will go.

3. Loosen jam nut Y. Adjust the clevis yoke by

turning the head of the bolt until the clevis pin

just makes contact with the rear of the slot in the

lever it connects with. Tighten jam nut Y.

4. Repeat steps 2 and 3 for the opposite side.

NOTE: A slight creep in reverse is acceptable

provided the wheel does not turn and the hydrostat

pump does not whine when the parking brake is on.

Right side adjustments

Contents

Main PARTS MANUAL MOWN MACHINE MAN0865 MZ2252K MZ2661K AVERTISSEMENT WARNING IMPORTANT MESSAGE TABLE OF CONTENTS WOODS NOTICE !!! ATTENTION! BECOME ALERT! Signal word denitions Page ASSEMBLY AND SETUP MAINTENANCE CHART ECNANETNIAM NOITAREPO E N I G N E SCILUARDYH ENIHCAM Page CHECK DAILY BATTERY Page HYDRAULIC SYSTEM WOODS SPARK PLUGS ENGINE OIL FUEL FILTER HEAVY DUTY CYCLONIC AIR CLEANER ENGINE COOLING WOODS CLEANING MACHINE WASHING MACHINE Page DECK LEVELING REAR DECK ROLLERS HEIGHT OF CUT COUNTERBALANCE SPRINGS WOODS PARKING BRAKE CONTROL LEVERS TRACKING HANDLES FRONT DECK LIP DAMPERS WOODS HYDROSTAT ADJUSTMENTS BELT REPLACEMENT CUTTERDECK BELT A PUMP-DRIVE BELT POWER UNITS ENGINES: DRIVE SYSTEM: OPERATOR PRESENCE INTERLOCK SYSTEM: WEIGHT: ENGINES WOODS LARENEG ENIGNE CONSTRUCTION: CUTTERDECK DRIVE SYSTEM: CUTTERDECKS Page FIGURE 1 UPPER ENGINE DECK ASSY FIGURE 1 ITEM PART NO. DESCRIPTION QTY ITEM PART NO. DESCRIPTION QTY * NOT ILLUSTRATED UPPER ENGINE DECK ASSY FIGURE 2 LOWER ENGINE DECK ASSY/CLUTCH FIGURE 2 LOWER ENGINE DECK ASSY/CLUTCH FIGURE 3 BUMPER FIGURE 3 FIGURE 4 FUEL TANKS/CONTROL PANEL FIGURE 4 FUEL TANKS/CONTROL PANEL FIGURE 5 BRAKES/REAR WHEEL FIGURE 5 BRAKES/REAR WHEEL FIGURE 6 OIL COOLER FIGURE 6 FIGURE 7 AIR COOLED HYDRAULICS FIGURE 7 AIR COOLED HYDRAULICS FIGURE 8 HYDROGEAR PUMP WOODS HYDROGEAR PUMP FIGURE 9 AIR COOLED WIRE HARNESS BATTERY ENGINE BLOCK (GROUND) (BLACK) (RED) AIR COOLED WIRE HARNESS FIGURE 9 Page SEAT ASSEMBL Y FIGURE 10 FIGURE 11 OPTIONAL FOLDING ROPS KIT (970410) FIGURE 11 OPTIONAL FOLDING ROPS KIT (970410) FIGURE 12 STEERING/DECK LIFT FIGURE 12 STEERING/DECK LIFT FIGURE 13 CRADLE ASSEMBLY FIGURE 13 CRADLE ASSEMBLY FIGURE 14 CRADLE & CASTER ASSEMBLY FIGURE 14 CRADLE & CASTER ASSEMBLY FIGURE 15 52" SIDE DISCHARGE FIGURE 15 52" SIDE DISCHARGE FIGURE 16 61" SIDE DISCHARGE FIGURE 16 61" SIDE DISCHARGE Page Page FIGURE19 DECALS-POWER UNIT FIGURE 19 Page Page Woods Equipment Company LIMITED WARRANTY (Mown MachineTM Zero-Turn Mowers and Woods BoundaryTM Utility Vehicles) LIMITED WARRANTY (Mown MachineTM Zero-Turn Mower and Woods BoundaryTM Utility Vehicle Replacement Parts)