Woods Equipment 872500G, 872502G, MZ2661K WOODS

13

WOODS MAINTENANCE

SPARK PLUGS

Remove each plug and check condition.

– Good operating conditions are indicated if the plug has a light coating of grey or tan deposit.

– A white blistered coating indicates overheating. A black coating indicates an “over rich” fuel mixture. Both

may be caused by a clogged air cleaner or improper carburetor adjustment.

– Do not sandblast, wire brush or otherwise attempt to repair a plug in poor condition. Best results are

obtained with a new plug.

– Set plug gap as specied in engine manual..

ENGINE OIL

Do not perform engine maintenance without the

engine off, spark plug wires disconnected and PTO

disengaged.

AFTER FIRST FIVE (5) HOURS

While the engine is warm:

1. Release the oil drain hose assembly from the

engine clip J. Lay hose assembly over the frame

edge.

2. Remove the rubber cap D from the tip of the

hose assembly and turn the drain valve to allow

oil to drain from the engine. Dispose of used oil

in accordance with local requirements.

3. Clean drain valve and tighten the plastic portion

of the drain valve back into the metal portion of

the valve. Replace rubber cap over the tip of the

valve. Replace hose assembly back into engine

clip.

4. Change oil lter.

5. Fill the crankcase with fresh oil to the full mark.

Do not overll. See engine manual for oil

specications.

DAILY

1. Check oil level with the dipstick.

2. If oil is needed, add fresh oil of proper

viscosity and grade. See engine manual for oil

specications. Do not overll.

3. Replace dipstick before starting engine.

PERIODIC OIL CHANGES

1. See engine manual for oil and lter change inter-

vals after the break-in period.

2. Follow instructions for rst oil change, above.

Contents

Main PARTS MANUAL MOWN MACHINE MAN0865 MZ2252K MZ2661K AVERTISSEMENT WARNING IMPORTANT MESSAGE TABLE OF CONTENTS WOODS NOTICE !!! ATTENTION! BECOME ALERT! Signal word denitions Page ASSEMBLY AND SETUP MAINTENANCE CHART ECNANETNIAM NOITAREPO E N I G N E SCILUARDYH ENIHCAM Page CHECK DAILY BATTERY Page HYDRAULIC SYSTEM WOODS SPARK PLUGS ENGINE OIL FUEL FILTER HEAVY DUTY CYCLONIC AIR CLEANER ENGINE COOLING WOODS CLEANING MACHINE WASHING MACHINE Page DECK LEVELING REAR DECK ROLLERS HEIGHT OF CUT COUNTERBALANCE SPRINGS WOODS PARKING BRAKE CONTROL LEVERS TRACKING HANDLES FRONT DECK LIP DAMPERS WOODS HYDROSTAT ADJUSTMENTS BELT REPLACEMENT CUTTERDECK BELT A PUMP-DRIVE BELT POWER UNITS ENGINES: DRIVE SYSTEM: OPERATOR PRESENCE INTERLOCK SYSTEM: WEIGHT: ENGINES WOODS LARENEG ENIGNE CONSTRUCTION: CUTTERDECK DRIVE SYSTEM: CUTTERDECKS Page FIGURE 1 UPPER ENGINE DECK ASSY FIGURE 1 ITEM PART NO. DESCRIPTION QTY ITEM PART NO. DESCRIPTION QTY * NOT ILLUSTRATED UPPER ENGINE DECK ASSY FIGURE 2 LOWER ENGINE DECK ASSY/CLUTCH FIGURE 2 LOWER ENGINE DECK ASSY/CLUTCH FIGURE 3 BUMPER FIGURE 3 FIGURE 4 FUEL TANKS/CONTROL PANEL FIGURE 4 FUEL TANKS/CONTROL PANEL FIGURE 5 BRAKES/REAR WHEEL FIGURE 5 BRAKES/REAR WHEEL FIGURE 6 OIL COOLER FIGURE 6 FIGURE 7 AIR COOLED HYDRAULICS FIGURE 7 AIR COOLED HYDRAULICS FIGURE 8 HYDROGEAR PUMP WOODS HYDROGEAR PUMP FIGURE 9 AIR COOLED WIRE HARNESS BATTERY ENGINE BLOCK (GROUND) (BLACK) (RED) AIR COOLED WIRE HARNESS FIGURE 9 Page SEAT ASSEMBL Y FIGURE 10 FIGURE 11 OPTIONAL FOLDING ROPS KIT (970410) FIGURE 11 OPTIONAL FOLDING ROPS KIT (970410) FIGURE 12 STEERING/DECK LIFT FIGURE 12 STEERING/DECK LIFT FIGURE 13 CRADLE ASSEMBLY FIGURE 13 CRADLE ASSEMBLY FIGURE 14 CRADLE & CASTER ASSEMBLY FIGURE 14 CRADLE & CASTER ASSEMBLY FIGURE 15 52" SIDE DISCHARGE FIGURE 15 52" SIDE DISCHARGE FIGURE 16 61" SIDE DISCHARGE FIGURE 16 61" SIDE DISCHARGE Page Page FIGURE19 DECALS-POWER UNIT FIGURE 19 Page Page Woods Equipment Company LIMITED WARRANTY (Mown MachineTM Zero-Turn Mowers and Woods BoundaryTM Utility Vehicles) LIMITED WARRANTY (Mown MachineTM Zero-Turn Mower and Woods BoundaryTM Utility Vehicle Replacement Parts)