OWNER SERVICE
The information in this section is written for operators who possess basic mechanical skills. Should you need help, your dealer has trained service technicians avail- able. For your protection, read and follow all safety information in this manual.
Regular preventive maintenance and immediate repair of broken or worn parts will insure maximum efficiency and long life.
NEVER GO UNDERNEATH EQUIPMENT. Never place any part of the body underneath equipment or between moveable parts even when the engine has been turned off. Hydraulic system
•Service work does not require going under- neath.
•Read Operator's Manual for service instruc- tions or have service performed by a qualified dealer.
Before leaving operator's seat, lower lift arms and put attachment on the ground. Engage brake, stop engine, remove key, and remove seat belt.
Do not allow bystanders in the area when oper- ating, attaching, removing, assembling, or servic- ing equipment.
Never perform service or maintenance with engine running.
Make sure shields and guards are properly installed and in good condition. Replace if damaged.
Keep hands and body away from pressurized lines. Use paper or cardboard, not hands or other body parts to check for leaks. Wear safety goggles. Hydraulic fluid under pressure can easily penetrate skin and will cause serious injury or death.
Make sure that all operating and service person- nel know that if hydraulic fluid penetrates skin, it must be surgically removed as soon as possible by a doctor familiar with this form of injury or gan- grene, serious injury, or death will result. CON-
TACT A PHYSICIAN IMMEDIATELY IF FLUID ENTERS SKIN OR EYES. DO NOT DELAY.
Make sure all hydraulic hoses, fittings, and valves are in good condition and not leaking before starting power unit or using equipment. Check and route hoses carefully to prevent damage. Hoses
must not be twisted, bent sharply, kinked, frayed, pinched, or come into contact with any moving parts. Operate moveable components through full operational range to check clearances. Replace any damaged hoses immediately.
Do not modify or alter or permit anyone else to modify or alter the equipment or any of its compo- nents in any way.
Make sure all safety decals are installed. Replace if damaged. (See Safety Decals section for location.)
CAUTION
Your dealer can supply original equipment hydraulic accessories and repair parts. Substitute parts may not meet original equipment specifica- tions and may be dangerous.
Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy,
Maintenance
Inspect for leaks and correct as necessary. Run engine at a slow idle, checking for leaks. Operate broom to ensure it is working properly.
Check the fluid level in skid steer reservoir and add fluid as required.
Procedure | Daily | 50 |
Hours | ||
|
|
|
Level brush | ✔ |
|
Check brush pattern | ✔ |
|
Clean air filter, skid steer | ✔ |
|
Hydraulic fittings and hoses, tighten |
| ✔ |
|
|
|
Grease fittings | ✔ |
|
Check hydraulic fluid level | ✔ |
|
Tighten hardware |
| ✔ |
|
|
|
16 Owner Service | MAN0661 (8/10/2007) |
|
|
