Woods Equipment PB720-2, PB600-2 manual Assembly Instructions, Dealer SET-UP Instructions

ASSEMBLY INSTRUCTIONS

DEALER SET-UP INSTRUCTIONS

Assembly of this pick-up broom is the responsibility of the WOODS dealer. It should be delivered to the owner completely assembled, lubricated and adjusted for normal conditions.

„Keep hands and body away from pressurized lines. Use paper or cardboard, not hands or other body parts to check for leaks. Wear safety goggles. Hydraulic fluid under pressure can easily penetrate skin and will cause serious injury or death.

„Make sure that all operating and service person- nel know that if hydraulic fluid penetrates skin, it must be surgically removed as soon as possible by a doctor familiar with this form of injury or gan- grene, serious injury, or death will result. CON-

TACT A PHYSICIAN IMMEDIATELY IF FLUID ENTERS SKIN OR EYES. DO NOT DELAY.

„Route hydraulic hoses carefully to prevent dam- age. Hoses must not be twisted, bent sharply, kinked, frayed, pinched, or come into contact with any moving parts. Operate moveable components through full operational range to check clearances. Replace any damaged hose immediately.

„Do not allow bystanders in the area when oper- ating, attaching, removing, assembling, or servic- ing equipment.

„Do not modify or alter or permit anyone else to modify or alter the equipment or any of its compo- nents in any way.

CAUTION

„Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hair, hands, hearing, and head; and respirator or filter mask where appropriate.

INSTALL GUTTER BRUSH (OPTIONAL)

Pick-up brooms are designed to carry only one gutter brush. Never install more than one gutter brush.

When using a gutter brush, only the main brush sweeps in the over-the-brush direction.

1.Remove plugs from holes in either the right or left side of the unit (depending on which side the gutter brush is to be installed).

2.Attach gutter brush mounting plate (15) and attachment plate (4) to broom hood using six cap screws (13), lock washers (25), and flat washers (22).

3.Insert pivot pin (40) into pivot assembly (5), place pivot arm (3) over pivot assembly and align holes. Secure assembly together using clevis pin (24) and cotter pin (30).

4.Insert bushings (6) into each end of attachment plate (4).

5.Slide pivot assembly into attachment plate and secure using bushing (24) and roll pin (31).

6.Attach motor (14) to motor mount plate (7) using four cap screws (18) and lock washers (26).

7.Attach brush head (1) to brush mounting plate (2) using four cap screws (17), flat washers (22), and lock nuts (27).

8.Attach motor mount plate to pivot arm using two carriage bolts (20), flat washers (23), lock washers (26), and hex nuts (28).

9.Attach brush assembly to motor using cap screw (16), lock washer (25), and flat washer (22).

10.Attach swing stop bolt (19) and two hex nuts (29) to the pivot arm.

11.Remove plugs from holes on the top side of the broom hood. Attach chain plate (11) to hood using three cap screws (16), lock washers (25), and flat washers (23).

12.Attach chain (35) and quick link (36) to top of pivot assembly and opposite end of chain to chain plate on the side of the broom hood.

Install Hydraulic Hoses

Use Figure 16 or Figure 17 to install hydraulic hoses for either right or left gutter brush application.

Complete Dealer Check List on page 22 before delivering broom to the customer.

MAN0661 (8/10/2007) Assembly 23