
SAFETY RULES
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
MAINTENANCE
Your dealer can supply original equipment hydraulic accessories and repair parts. Substitute parts may not meet original equipment specifica- tions and may be dangerous.
To prevent contamination during maintenance and storage, clean and then cover hose ends, fit- tings, and hydraulic ports with tape.
Do not operate the pump with pressure over 3000 psi. Higher pressures can rupture hydraulic components and can cause personal injury.
Adjustment of system relief pressure must be done by a qualified, experienced dealer. Incorrect adjustment can result in system failures and seri- ous personal injury.
Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy,
Do not allow bystanders in the area when oper- ating, attaching, removing, assembling, or servic- ing equipment.
Do not modify or alter or permit anyone else to modify or alter the equipment or any of its compo- nents in any way.
Never go underneath equipment (lowered to the ground or raised) unless it is properly blocked and secured. Never place any part of the body under- neath equipment or between moveable parts even when the engine has been turned off. Hydraulic system leak down, hydraulic system failures, mechanical failures, or movement of control levers
can cause equipment to drop or rotate unexpect- edly and cause severe injury or death. Follow Oper- ator's Manual instructions for working underneath and blocking requirements or have work done by a qualified dealer.
Be sure attachment is properly secured, adjusted, and in good operating condition. Coupler lockpins must be fully extended and properly engaged into attachment retaining slots.
Never perform service or maintenance with engine running.
Keep all persons away from operator control area while performing adjustments, service, or maintenance.
Tighten all bolts, nuts, and screws to torque chart specifications. Check that all cotter pins are installed securely to ensure equipment is in a safe condition before putting unit into service.
Make sure all safety decals are installed. Replace if damaged. (See Safety Decals section for location.)
Make sure shields and guards are properly installed and in good condition. Replace if damaged.
Do not disconnect hydraulic lines until all sys- tem pressure is relieved. Lower unit to ground, stop engine, and operate all hydraulic control levers.
STORAGE
Follow manual instructions for storage.
Keep children and bystanders away from stor- age area.
Alitec Broom Safety Rules (7/15/2005)