3.Place the second section on the core with the drive pins on either side of tube 2. Make sure drive pins angle downward (Figure 14).
Figure 14. Second Section
4.Put the third section on with the drive pins around tube 3. Make sure drive pins angle upward.
5.Slide sections on until the core is full. Make sure to alternate the tubes used and the direction of the drive pins.
Assemble Unit
1.Attach the section retainer and bearing mounting plate with previously removed hardware.
2.Lay core on ground. Lower body over core.
3.Attach bearing mounting plate with previously removed hardware.
4.Reattach motor mount with previously removed hardware.
NOTES
MAN0661 (8/10/2007) | Dealer Service 21 |
|
|
