1.Clevis
2.5/8 NC x 4 Cap screw
3.5/8 NC Hex nut
4.Pad assembly
5.Tube assembly
6.Screw assembly
7.Puller link
Figure 18. Crossbar Removal
Crossbar Installation
1.Using emery cloth (220 or finer), remove surface rust, and foreign material from hub, splined gearbox vertical shaft, and crossbar. See Figure 19.
Figure 19. Typical Crossbar and Gearbox Shaft
2.Install crossbar (2) on splined shaft. See Figure 20. Install nut (3). Torque nut to 450 lbs-ft. Install cotter pin.
Figure 20. Crossbar Installation
MAN0577 (6/29/2007) | Dealer Service 35 |
|
|
