![](/images/new-backgrounds/1097150/9715087x1.webp)
Install SMV Emblem (Semi-Mounted)
See Figure 30.
1.Attach SMV socket (35) to deck bracket with two carriage bolts (38) and lock nuts (39).
2.Attach SMV emblem (37) to SMV bracket (36) using two round head cap screws (40) and hex nuts (41).
3.Insert SMV bracket (36) and emblem (37) into socket (35).
ALL MODELS
FILL GEARBOXES
NOTICE
■Gearbox is not filled at the factory. Prior to delivery to customer, make sure gearbox is filled only
Side Gearboxes
1.Make sure vent plug hole is clear (installed by dealer).
2.Remove plug on side of gearbox
3.Fill gearbox until oil runs out the side plug on gearbox. Use a high quality gear oil with a viscosity index of 80W or 90W and an API service rating of
4.Install side plug and vent plug.
Center Gearbox
1.Make sure dipstick vent hole is clear.
2.Fill gearbox until oil level is between rings with dipstick seated. Use a high quality gear oil with a viscosity index of 80W or 90W and an API service rating of
3.Install dipstick.
INSTALL CHAIN SHIELDING (OPTIONAL)
Full chain shielding must be installed when operating in populated areas or other areas where thrown objects could injure people or damage property.
•If this machine is not equipped with full chain shielding, operation must be stopped when any- one comes within 300 feet (92 m).
•This shielding is designed to reduce the risk of thrown objects. The mower deck and protec- tive devices cannot prevent all objects from escaping the blade enclosure in every mowing condition. It is possible for objects to ricochet and escape, traveling as much as 300 feet (92 m).
Full chain shielding is required for all
The chain shield assemblies are ready for installation when you receive them.
Install front and rear chain shielding as shown using carriage bolts (9) and lock nuts (10).
9. 3/8 NC x
10. 3/8 NC Flange lock nut
Figure 31. TS1680 Chain Shielding Installation
44 Assembly | MAN0577 (6/29/2007) |
|
|