J<KLG
J_`gg`e^JkiXgI\dfmXc
Jkfg8[aljkd\ek
To ensure that your bandsaw arrives without damage to the hinge system, a shipping strap was installed. After removing the shipping strap, you will have to make a series of adjustments, beginning with the feed stop bolt.
Kfi\dfm\k_\j_`gg`e^jkiXgXe[X[aljkk_\]\\[jkfg Yfck#[fk_\j\jk\gj1
(% Remove the shipping strap hex bolt and strap with a 12mm wrench, as shown in =`^li\0.
Efk\1 B\\gk_`jj_`gg`e^jkiXg`ek_\\m\ekk_Xkpfl dljkkiXejgfikfij_`gk_\YXe[jXn%
)% Adjust the feed stop bolt and jam nut with a 14mm wrench (=`^li\('), so the bandsaw blade teeth are just below the table surface when the cut is complete.
JhlXi`e^M`j\kf9cX[\
To ensure that your bandsaw will make cuts that match the degree scale, you must make sure to square the vise to the blade.
KfjhlXi\k_\m`j\kfk_\YcX[\#[fk_\j\jk\gj1
(% Rotate the headstock until the pointer reads "0" on the tabletop scale, and tighten the headstock lock lever so the headstock stays indexed at zero.
)% Using a 6mm wrench, loosen the two cap screws that hold the vise to the table, as shown in =`^li\((.
*% Using a small machinists square, adjust the vise so it is square to the blade.
+% Tighten the two cap screws, so the vise and blade are square with one another.
Shipping Brace
=`^li\0% Removing shipping strap.
Feed Stop
Bolt
=`^li\('% Feed stop bolt.
Headstock
Lock
Lever
=`^li\((% Squaring vise to blade,
headstock, and table scale.
