K\jkIle
J<KLG
Once the assembly is complete, test run your machine to make sure it runs properly.
If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the KiflYc\j_ffk`e^ on GX^\*).
If you still cannot remedy a problem, contact our Tech Support at (360)
Kfk\jkilek_\dXZ_`e\#[fk_\j\jk\gj1
(% Make sure you understand the safety instructions at the beginning of the manual, and verify that the machine is setup properly.
)% Ensure all tools and objects used during set up are cleared away from the machine.
*% Connect the machine to the power source.
+% Start the bandsaw while keeping your finger near the ON/OFF switch at all times during the test run. The bandsaw should run smoothly with little or no vibration.
—Strange or unusual noises should be investigated and corrected before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.
Gifa\Zk`c\j k_ifne ]ifd k_\ dXZ_`e\ Zflc[ ZXlj\ j\i`flj \p\ `ealip% N\Xi jX]\kp ^cXjj\j kf i\[lZ\ k_\ i`jb f] `ealip%
Cffj\ _X`i Xe[ Zcfk_`e^ Zflc[ ^\k ZXl^_k`edXZ_`e\ipXe[ZXlj\j\i`flj g\ijfeXc `ealip% B\\g cffj\ Zcfk_`e^ ifcc\[ lg Xe[ cfe^ _X`i k`\[ lg Xe[ XnXp]ifddXZ_`e\ip%
,% Turn the machine F==.
