N_\\cj#=\\k#Xe[ :XY`e\k
J<KLG
This bandsaw is shipped with four rubber feet with posts and two wheels with an axle. It is your option to install four rubber feet if you do not need to move the bandsaw, or install the axle and wheels if you need to move the bandsaw regularly.
Kf`ejkXcck_\n_\\cj#]\\k#Xe[k_\ZXY`e\k#[fk_\j\ jk\gj1
(% At the end of the base with the axle holes, insert the axle into the base (see =`^li\+).
)% Slide a 17mm flat washer and wheel onto each end of the axle, followed by another 17mm flat washer and cotter pin.
*% Thread a
+% Thread rubber feet into the base (see =`^li\+).
,% Position the base on the floor, and adjust the feet until the base is level and stable.
.% Position the front and rear panels on the base and install the panels to the base with four
/% Position the left panel between the front and rear panels, and secure it in place with six
=`^li\+% Installing wheels and feet.
=`^li\,% Front and rear panels installed.