-14-
D('*0()$Jg\\[;i`ccGi\jj
J<KLG
+% Place the rack inside of the table bracket, mesh it
together with the pinion, and slide the table sup-
port/rack assembly over the column, as shown in
=`^li\((.
,% Slide the column ring over the column with the bev-
eled edge facing down (=`^li\()), fit the beveled
edge of the column ring over the rack, and tighten
the setscrew.
Efk\1 DXb\jli\k_\iXZb`jj\Xk\[]`idcp`e k_\
cfn\ii`e^Y\]fi\k`^_k\e`e^k_\j\kjZi\n%;fefk
fm\i$k`^_k\ek_\j\kjZi\nfipfldXpjgc`kk_\ Zfc$
ldei`e^%
-% Install the crank handle over the pinion shaft, and
tighten the setscrew in the crank handle against the
flat part of the pinion shaft.
.% Thread the handle into the crank handle.
/% Thread the large lock lever into the back of the
table bracket approximately three turns, for now.
0% Thread the small lock lever into the front part of
the table bracket approximately three turns, for
now. The assembly should now be assembled as
shown in =`^li\(*.
=`^li\((% Sliding table bracket and rack
over column.
=`^li\()% Correct column ring
orientation.
=`^li\(*% Handles and lock levers
installed.
Large Lock
Lever Crank Handle
Small Lock
Lever