Possible problem: The rear carriage may be drag- ging on the rear rail.
Solution: Although this is unlikely, it is possible if the rear roller (#51) is pressed onto its bear- ing (#36) too far. Any one of the following approaches may be used:
a.
b. Shift the roller on the bearing in a press.
c. Contact Woodstock International for replace- ment parts (#36, 49, 51 and 52).
d. Use a file to enlarge the rail
side of the front carriage. Loosen the mounting screws slightly and shift the carriage so that it is 90˚ to the fence. Figure 33. Tighten the mounting screws and reinstall the clamping jaws. Check and adjust the front clamping pressure as described in Section III, Part D.
F. FENCE WILL NOT ADJUST
PARALLEL TO BLADE
Possible problem: The front carriage is not mount- ed square to the underside of the fence.
Solution: Remove the clamping jaws to gain access to the mounting screws (#37) on the under
Figure 33. Squaring carriage on fence.
Shop Fox® Fence |
