General | Woodstock W1676 manual

!	Disconnect power to the
	machine when perform-
	ing	any	maintenance,
	assembly		or	adjust-
	ments. Failure to do this
	may	result in		serious
	personal injury.

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.

General

While the main components of the Shop Fox® W1676 are assembled at the factory, some assembly is required. The following is the rec- ommended sequence best suited for final assembly.

TOOLS REQUIRED (NOT INCLUDED): You will need a 6" adjustable wrench, 12mm open-end wrench, flathead screwdriver, Phillips® screw- driver and 4mm Allen® wrench.

-13-

Image 15

Woodstock W1676 instruction manual General

Contents

Combination Sander Page Table Of Contents Introduction About Your NEW Sander Woodstock Service and Support Machine Specifications Warranty and Returns Disconnect machine when cleaning, adjusting or servicing Safety First Keep proper footing and balance at all times Keep fingertips away from the moving belt or disc Additional Safety Instructions For Sanders Grounding Electrical Requirements110V Operation Extension Cords 220V Operation Never place fingers close to moving disk Avoiding Potential Injuries Unpacking Assembly Instructions QTY Clean Up General Sanding Unit To Base Idler RollerSanding Disc Dust Ports Back Stop To install the working table next to the disc Working TableQuick Release Adjustments Belt Tracking/Tension To adjust the tracking Unplug the combination sander Idler Guard To adjust the tension Step Vertical Positioning To replace abrasive sanding disc Changing Abrasive Disc Table Tilt To adjust the working table angle Operations Testing Curved Sanding Horizontal Sanding Sanding end grain Disc Sanding Maintenance Table And BaseLubrication Closure 220VOLT W1676 Combination Sander 120 107 90A 110 104 122 Dust Cover Page Page Warranty Card BOX BELLINGHAM, WA