![](/images/new-backgrounds/1202568/202568109x1.webp)
Chapter 5 Cajun Campus CLI (Command Line Interface)
Set logout command
The set logout command is used to set the number of minutes until the system automatically disconnects an idle session.
The syntax for this command is: set logout <timeout>
<timeout> | Number of minutes (0 to 999) until the system automatically |
| disconnects an idle session. Setting the value to 0 disables the |
| automatic disconnection of idle sessions |
| Default = 15 |
Examples:
To set the number of minutes until the system disconnects an idle session automatically:
Console> (enable) set logout 20
Sessions will be automatically logged out after 20 minutes of idle time.
Console> (enable)
To disable the automatic disconnection of idle sessions:
Console> (enable) set logout 0
Sessions will not be automatically logged out.
Console> (enable)
Set ntp server command
The set ntp server command is used to set the ntp server address.
The syntax for this command is: set ntp server <ip>
ip | IP address of the ntp server. |
Set ip route command
Use the set ip route command to add IP addresses to the IP routing table. You can configure one default gateway up to
The syntax for this command is: set ip route destination gateway
destination | IP address of the network, or specific host to be added |
gateway | IP address of the router. |
Cajun P333T User’s Guide | 45 |