Vertical Positioning
The belt sander arm can be moved to a vertical arrangement.
1.Remove the belt dust port.
2.Loosen the two nuts located on the bracket behind the pulley cover as shown in Figure 23. We recommend using a 12mm
3.When the nuts are loose, rotate the sanding belt frame to the vertical position as shown in Figure 24.
4.Tighten down the nuts that were loosened in
Step 2.
The working table can also be repositioned next to the vertical surface of the sanding belt. Remove the working table assembly and support bar from the sander base, and reposition it in the mounting hole behind the motor as shown in
Figure 25.
