Figure 18. Wire inside and around pipe.
Figure 19. Ground wire secured to collector.
Figure 20. Ground wires bypassing blast gate.
System Grounding
Static electricity is generated by the collision of dust particles as they travel through dust collec- tion ducting. Plastic ducting acts as an insulator, allowing the static charge to build. The
If using metal ducting for the collection system, ensure that each machine in the system forms a conductive connection through the entire length of duct work and back to the dust impeller/motor assembly. If plastic hose or blast gates are used between metal ducting anywhere in the system, 12 gauge bare copper will need to be used to “jump” the plastic conductive barri- er and complete the conductive line between the machine and the dust impeller/motor assembly.
When the system is to be made up entirely of plastic hoses and blast gates, wrap 12 gauge bare copper wire around the hose from the dust impeller/motor assembly to the machine body. Another wire should be placed inside the pipe/hose with exit holes for the wire at each end of the hose run. After exiting the hose at each end, the wire should connect to the dust impeller/motor assembly and the machine body as shown in Figures 18 and 19. If the system has branches, place wires in the same fashion and connect to the wires on the main pipe/hose with wire nuts. If blast gates are to be used, drill exit and entrance holes on both sides of the blast gate to allow wire to be fed out of and into the system as shown in Figure 20.
ASSEMBLY
