Collectors
The (2) collectors attach to each of the outlet duct flanges and are later secured to the base with the support bracket assemblies. The inside of the collectors are cone shaped to force the air around in a circular motion. Be sure that the inside taper (cone) is pointing downward and that the collector inlet flange faces the outlet duct flange. Insert one of the rubber gaskets between the outlet duct flange and the collec- tor flange. Secure with (8)
Figure 11. Attaching the collector
to outlet flange.
ASSEMBLY
Support Brackets
Each support bracket assembly consist of an upper and a lower bracket. The lower brackets bolt to the base and to the side of the collec- tors. The upper brackets bolt to the side of the collectors and extend upward. The upper brack- ets have hooks that support the upper bags.
1.Attach each lower bracket to the top edge of the base plate using (4)
2.Line up the two holes of each upper bracket with the holes on each lower bracket, as well as the holes on the collector sides. Secure the upper and lower brackets to the collectors with (4)
