Adjustments, Fence | Woodstock W1694 specs

ADJUSTMENTS

ADJUSTMENTS

UNPLUG the power cord before you do any assem- bly or adjustment tasks! Otherwise, serious per- sonal injury to you or oth- ers may occur!

Fence

The fence assembly has two primary methods of adjustment:

•The face of the fence is adjustable relative to the table surface.

•The fence position is adjustable across the width of the table.

To adjust the fence face angle relative to the table surface, do these steps:

1.Loosen the fence tilting handle (Figure 20).

2.Move the fence face to the desired position. Precise angle stops will be discussed in the Fence Angle Stops sub-section.

3.Tighten the fence tilting handle.

To adjust the fence position across the width of the table, do these steps:

1.Loosen the fence sliding handle (Figure 20).

2.Move the fence to the desired position across the width of the table. The fence position is adjustable to accommodate workpieces of varying widths and to pro- mote even blade usage and wear.

3.Tighten the fence sliding handle.

Fence Tilting

Handle

Fence Sliding

Handle

Figure 20. Fence bracket assembly.

-16-

Image 18

Woodstock W1694 instruction manual Adjustments, Fence

Contents

Bench TOP Jointer Page Contents Woodstock Service and Support IntroductionAbout Your New Jointer Warranty and Returns Specifications Safety Standard Safety Instructions #16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Avoiding Potential Injuries Never surface plane without push blocks Grounding Electrical Requirements110V Operation Extension Cords Assembly UnpackingInventory Initial Cleaning Shop PreparationDust Collection To attach the rubber feet, do these steps Rubber FeetFence Support To attach the fence support, do these steps Fence Assembly To assemble the fence assembly, do these steps Dust Port To install the 90˚ stop slide, do these steps90˚ Stop Slide To connect the dust port to a trash can, do these steps To connect the dust port to a trash bag, do these steps Assembling the trash bag support Adjustments Fence To adjust the 90˚ angle stop, do these steps Fence Angle Stops To adjust the 45˚ inward angle stop bolt, do these steps To adjust the 45˚ outward angle stop bolt, do these steps Blade Height To check the cutterhead blade height, do these steps To adjust the depth of cut Depth Of Cut Blade Guard Blade guard in use Operations Test RunTo test run the Model W1694, do these steps Operation Requirements Correct and incorrect grain Alignment to cutterhead Surface Planing To perform a surface planing operation, do these steps Edge Jointing To perform an edge jointing operation, do these steps Bevel Cutting To perform a bevel cutting operation, do these Table Surface MaintenanceGeneral Sharpening Blades Replacing Blades To replace the cutterhead blades, do these steps Guard Spring LubricationTo replace a worn out blade guard spring, do these steps Drive Belts Motor BrushesTo replace the drive belts, do these steps Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA