Woodstock W1706 owner manual Dust Collection, Recommended CFM at Dust Port

Model W1706 (Mfg. Since 8/10)

12. Place the fence assembly onto the front rail and position it to the left of the table insert, then secure it in place by pressing down on the lock lever (see Figure 12).

Lock Lever

Figure 12. Fence secured in place.

Dust Collection

Recommended CFM at Dust Port: 400 CFM

Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must take into account many variables, including the CFM rating of the dust collector, the length of hose between the dust collector and the machine, the amount of branches or Y's, and the amount of other open lines throughout the system. Explaining this calculation is beyond the scope of this manual. If you are unsure of your system, consult an expert or purchase a good dust collection "how-to" book.

SETUP

DO NOT operate this machine without an adequate dust collection system. This machine creates substan- tial amounts of wood dust while operating. Failure to use a dust collection system can result in short and long-term respiratory illness.

To connect a dust collection hose, do these steps:

1.Slide a 4" dust hose over the dust port and secure it in place with a hose clamp, as shown in Figure 13.

2.Tug on the hose to make sure it is secure.

Note: A tight fit is necessary for proper dust collection.

-13-

Figure 13. Dust collection hose connected

to the dust port.