Sanding Belt Installation | Woodstock W1751 instruction

W1751 25" Wide-Belt Sander

Sanding Belt Installation

SET UP

1.Before installing the belt, clean the protective grease from the upper metal sanding belt roller as per the Cleaning Machine instructions on Page 11.

2.DISCONNECT THE SANDER FROM POWER, but keep the air pressure applied into the machine.

3.Turn the sanding head lock lever counterclockwise and remove the lever and the steel spacer block.

4.Locate the arrows on the inside of the sanding belt. These arrows show the direction that the sanding belt is designed to rotate during operation. Facing the inside of the left-hand access door, the sanding belt will rotate counterclockwise.

5.Install the sanding belt as shown in Figure 8, and center it on the rollers and in between the ceramic limit switch levers.

6.Reinstall the steel spacer block, the sanding head lock lever, and turn the lever clockwise to lock the headstock.

Sanding Belt Tensioning

When air is applied to the system (75 PSI), the switch shown in Figure 9 automatically sets the belt to the cor- rect tension. When the air pressure is connected and the switch is flipped up, the belt will automatically tighten to the correct tension. Flipping the switch down will immediately exhaust the air and release the belt ten- sion.

You must tension the sanding belt before starting the sander, and de-tension the belt when sander is not in use, or you will stretch the belt.

Figure 8. Installing sanding belt over rollers. The arrows on the inside must point in the same direction as belt rotation.

Figure 9. Belt tension knob.

-14-

Image 16

Woodstock W1751 owner manual Sanding Belt Installation, Sanding Belt Tensioning

Contents

WIDE-BELT Sander Page Contents Service Introduction Woodstock Technical Support Specifications Controls and Features Standard Safety Instructions Disconnect machine when cleaning, adjusting or servicing Keep stable footing and balance at all times Additional Safety Instructions for Sanders Extension Cords 220V OperationGrounding Box Contents Unpacking Machine Placement Cleaning Machine Platen AssemblyHandwheel Crank Air Supply Ducting Sanding Belt Installation Sanding Belt Tensioning To adjust the pressure rollers, do these steps Pressure Roller Depth and Alignment Pressure roller adjuster Pressure Roller Tension Control Panel Conveyor Belt Start and Stop ButtonsSanding Load Amp Meter Sanding Belt Start and Stop Buttons Test Run General OperationTo complete the test run, do these steps Using the Amp Draw Meter Setting Feed SpeedTo change the conveyor belt speed do these steps Emergency Stop Changing Sanding BeltsTo use the emergency stop, do these steps Using the Platen Basic SandingTip To sand a workpiece, do these steps Operations To adjust the jet air flow, do these steps Jet Air Flow Belt Tracking Belt tracking knob and lever Belt Tracking procedure on Page 24 or the Jet Belt Oscillation Speed Cleaning Belts GeneralLubrication Maintaining Air System To check the condition of the brake pads, do these steps Brake ServiceTo replace the brake pads, do these steps Changing V-Belts Change the V-belt as follows Belt Tension To tension the V-belts, do these steps Conveyor belt tension Tracking adjustment locations Conveyor Belt Tension Tracking Pressure Rollers Gauge boards placed under Pressure rollers Belt Tracking Limit Switch To adjust the belt tracking limit switches, do these steps Troubleshooting Motor & Electrical Sanding and Results Electrical Box Component Locations See Figure Emergency Power lamp Digital amp W1751 Limit Switch Wiring Diagram W1751 General Wiring Diagram Sanding Motor Parts List PART# Description Conveyor System Conveyortable Upper Contactrollerbase Sanding DrumSystem BALLBEARING6005ZZ Upper Machineframe Air System Parts List Parts Electrical Connections Box Description Accessories Accessories List Label Placement Labels List Warranty Warranty Registration Comments BOX BELLINGHAM, WA