Woodstock W1761/W1762 Digital Readout, To adjust the tilt indicator arrow, do these steps

W1761/W1762 12" Table Saw with Riving Knife

3.Move the blade angle to 30°, or remove the panel on the right side of the cabinet to access the 45° stop bolt.

4.Using a 12mm wrench, loosen the jam nut (Figure 67) on the 45° stop bolt, adjust the stop bolt up or down, then check to see if the blade is 45° to the table.

5.Continue adjusting the stop bolt until it contacts the cabinet when the blade is at 45°.

6.Tighten the jam nut.

To adjust the tilt indicator arrow, do these steps:

1.Set the 90° stop bolt (see instructions on Page 49).

2.Loosen the blade height handwheel set screw and remove the handwheel.

3.Loosen the Phillips head screw shown in Figure 68 and move the tip of the indicator to 0°.

4.Tighten the Phillips head screw and reinstall the handwheel.

Digital Readout

45° Stop Bolt

Jam Nut

Figure 67. 45° stop bolt and jam nut.

Indicator

Phillips Head

Screw

SERVICE

The digital readout displays the current blade angle. We recommend you set the readout after verifying the 90° and 45° blade tilt stops.

To set the digital readout, do these steps:

1.Ensure the 90° stop bolt is set (see Blade Tilt Stops on Page 49.

2.Move the blade angle to 0° and press the 0° SET button (Figure 69) for several seconds until the readout displays 0.00.

3.Move the blade angle to 45° and press the SET but- ton for several seconds until the readout displays 45.0.

Note: If you move the blade angle handwheel when the power is disconnected, the digital readout will be incorrect when the saw is reconnected.

Figure 68. Tilt indicator arrow.

0° Set Button 45° Set Button

Figure 69. Digital readout.

-50-