W1761/W1762 12" Table Saw with Riving Knife

5.While an assistant holds the extension table, fasten the 93" front rail to the extension table with three M8-1.25 x 25 flat head screws, flat washers and hex nuts (Figure 16). Finger tighten for now.

6.

Fasten the 79" rear rail to the extension table with

 

 

three M8-1.25 x 25 cap screws, lock washers, flat

 

 

washers, and hex nuts, as shown in Figure 17.

 

 

Finger tighten for now.

 

7.

Align the table and extension table with a straight-

Figure 16. Front rail/table fastener

locations.

 

edge (Figure 18), then tighten the fasteners in

 

 

 

Figure 16 with a 5mm hex wrench and 13mm

 

 

wrench.

 

8.

Repeat the leveling procedure and tighten the fas-

 

 

teners in Figure 17 with a 6mm hex wrench and

 

 

13mm wrench.

 

9.

Using a 17mm wrench, tighten the hex bolts shown

 

 

in Figure 15.

 

10.

Thread a 3/8-16 hex nut on each foot and thread the

Figure 17. Rear rail/table fastener

 

feet into the bottom of the support legs as shown in

locations.

 

 

Figure 19.

SET UP

Figure 18. Leveling main extension table.

Support Leg

Hex Nut

Foot

Figure 19. Foot installed on support leg.

-19-

Page 32 Page 34
Page 33
Image 33
Woodstock W1761/W1762 owner manual Leveling main extension table Support Leg Hex Nut Foot
Page 32 Page 34
Top Page Image Contents