Woodstock W1814 Kfj\kk\0²jkfg#fk\j\jk\gj1, Limit Plate Limit Block Rear Slot, Block Set

N(/(+Fne\ijDXelXcD]^%('&'/"

J<IM@:<

>\e\iXc

This section covers the most common service adjustments or procedures that may need to be made during the life of your machine.

If you require additional machine service not included in this section, please contact Woodstock International Technical Support at (360) 734-3482 or send e-mail to: k\Z_$jlggfik7j_fg]fo%Y`q.

J\kk`e^=\eZ\8e^c\Jkfgj

This section provides instructions for setting the fence stops precisely at 45° inward, 90°, or 45° outward.

Efk\1Kf\ejli\XZZliXk\i\jlckjn_\e\[^\af`ek`e^#

Z_\Zbk_\XZZliXZpf]k_\j\j\kk`e^j]i\hl\ekcpdfek_cp XkXd`e`dld n`k_XdXZ_`e`jkjZfdY`eXk`fejhlXi\Xe[ i\$X[aljkk_\d`]e\Z\jjXip%

Kfj\kk_\0'²jkfg#[fk_\j\jk\gj1

(% DISCONNECT JOINTER FROM POWER SOURCE!

)% With the fence positioned over the bed and the sliding handle locked, loosen the fence tilting handle.

*% Press the forward tab of the limit plate into the rear slot of the limit block.

+% Pull the fence as far as it will go towards 90º (perpendicular to the table), then tighten the fence tilting handle.

 Efk\1N_\epflglcck_\]\eZ\kfnXi[j0'²#`kn`cc jkfgn_\e`k_`kjk_\c`d`kYcfZbj_X]k%

,% Use a square to check the angle of the fence, as shown in =`^li\41.

—If the fence is perpendicular to the table, move ahead to set the 45º stops.

—If the fence is not perpendicular to the table, adjust the 90º stop by doing Jk\gj-$0.

D8B< JLI< k_Xk pfli dXZ_`e\ `j legcl^^\[ [li`e^ Xcc j\im`Z\ gifZ\$ [li\j @] k_`j nXie`e^ `j `^efi\[# j\i`$ fljg\ijfeXc`ealipdXpfZZli%

Limit Plate	Limit Block
	Rear Slot
Tab		Limit
		Block Set
		Screw
Inward Stop	Limit Block	Jam
	Shaft	Nut

=`^li\+'% Fence stop parts identification.

=`^li\+(% Checking the 90º stop.

J<IM@:<

-27-