Woodstock W1814 manual Zb`e&8aljk`eBe`\ ?\`k, =`li\, KfXaljkk\be`\\`k#fk\j\jk\gj1

	N(/(+Fne\ijDXelXcD]^%('&'/"
/% Install the fence tilting handle by screwing the
handle shaft into the bracket assembly, as shown in
=`^li\(/.		Outward
		Stop
:_\Zb`e^&8[aljk`e^Be`]\
?\`^_k	Bracket	Fence Tilting
The knives MUST be level with the outfeed table when
	Assembly
		Handle Shaft
they are at top dead center (their highest point during
rotation) or the workpiece cannot be safely fed across the	=`^li\(/% Installing the fence tilting
jointer.
		handle.

J<KLG

To check the knife height, do these steps:

1.DISCONNECT JOINTER FROM POWER SOURCE!

)% Place a straightedge on the outfeed table so it extends over the cutterhead. For best results, use a straight- edge that will stand on edge without having to be held in place.

3.Rotate the cutterhead under the straightedge, as illus- trated in =`^li\(0.

—If your cutterhead knives are even with or brush the straightedge and move it slightly (1/8") forward and back when you turn the cutterhead, then no adjustments are necessary.

—If the knives fall below the straightedge, or if the knives lift the straightedge and move it more than 1/8" when you rotate the cutterhead, the knives must be adjusted.

KfX[aljkk_\be`]\_\`^_k#[fk_\j\jk\gj1

JkiX`^_k\[^\
Flk]\\[	@e]\\[

=`^li\(0% Illustration of a typical

cutterhead alignment setup.

Cutterhead Knife

Clamp Screws

=`^li\)'% Cutterhead knife clamp screws.

(% DISCONNECT JOINTER FROM POWER SOURCE!

)% Block the cutterhead guard back so the cutterhead is fully exposed.

*% Locate the knife clamp screws and knife adjustment jack screws (see =`^li\j2021).

 Efk\1Pfln`ccg\i]fidk_\gifZ\[li\`eJk\gj($/ ]fi\XZ_f]k_\knfbe`m\j%

+% Use a 4mm hex wrench to loosen the four knife clamp screws.

Knife

Adjustment

Jack Screws

=`^li\)(% Knife adjustment jack screws.

-16-